Filter
Top Products
Operating the VS-66HDCP 6 x 6 DVI Matrix Switcher
11
11
7.1 Routing Inputs to Outputs
To route an input to an output:
• Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:
• Press ALL followed by an IN button. The input is routed to all outputs
7.2 Disconnecting the Outputs
To disconnect one output:
• Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:
• Press the ALL button and then press OFF. This disconnects all the
outputs
7.3 Storing and Recalling a Setup
You can use the STO and RCL buttons to store up to 12 setups
1
and then
recall them, as
Figure 3 illustrates:
Figure 3: SELECTOR Buttons
2
To store a setup:
1. Set the machine to the desired setup.
For example, press the OUT 3 button and IN 4 button
3
2. Press the STO button.
The STO button flashes.
.
3. Select an OUT or IN SELECT button to store the machine setup (for
example, OUT 5).
4. Press the LOCK button
4
1 IN 1 is used for setup # 1 and OUT 1 is used for setup # 7
to store the current setup.
In this example, the OUT 5 button stores the setup.
2 The gray numbers (1 to 12) in Figure 3 that illustrate the corresponding store/recall configuration numbers, are for the
purpose of illustration only and do not actually appear on the buttons
3 You can set all the switcher IN-OUT buttons
4 You have to press the LOCK button within 10 seconds, before the store operation times out