Filter
Top Products
2
Lenovo G560 Hardware Maintenance Manual
General safety
Follow these rules below to ensure general safety:
Observe a good housekeeping in the area where the machines are put •
during and after the maintenance.
When lifting any heavy object: •
1. Make sure that you can stand safely without slipping.
2. Distribute the weight of the object equally between your feet.
3. Use a slow lifting force. Never move suddenly or twist when you attempt
to lift it.
4. Lift it by standing or pushing up with your leg muscles; this action could
avoid the strain from the muscles in your back. Do not attempt to lift any
object that weighs more than 16 kg (35 lb) or that you think is too heavy
for you.
Do not perform any action that causes hazards to the customer, or that •
makes the machine unsafe.
Before you start the machine, make sure that other service representatives •
and the customer are not in a hazardous position.
Place removed covers and other parts in a safe place, keeping them away •
from all personnel, while you are servicing the machine.
Keep your toolcase away from walk areas so that other people will not trip it •
over.
Do not wear loose clothing that can be trapped in the moving parts of the •
machine. Make sure that your sleeves are fastened or rolled up above your
elbows. If your hair is long, fasten it.
Insert the ends of your necktie or scarf inside clothing or fasten it with the •
nonconductive clip, about 8 centimeters (3 inches) from the end.
Do not wear jewelry, chains, metal-frame eyeglasses, or metal fasteners for •
your clothing.
Attention: Metal objects are good electrical conductors.
Wear safety glasses when you are hammering, drilling, soldering, cutting •
wire, attaching springs, using solvents, or working in any other conditions
that may be hazardous to your eyes.
After service, reinstall all safety shields, guards, labels, and ground wires. •
Replace any safety device that is worn or defective.
Reinstall all covers correctly before returning the machine to the customer.•
Fan louvers on the machine help to prevent the overheating of internal •
components. Do not obstruct fan louvers or cover them with labels or
stickers.