Filter
Top Products
Statement 2:
CAUTION:
When replacing the lithium battery, use only a battery recommended by the
manufacturer. If your system has a module containing a lithium battery,
replace it only with the same module type made by the same manufacturer.
The battery contains lithium and can explode if not properly used, handled, or
disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
To remove the battery, do the following:
1. Read the safety information (see “Safety” on page vii and “Installation
guidelines” on page 37).
2. Follow any special handling and installation instructions that come with the
battery.
3. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
4. Carefully position the server flat on its side so that it is facing up.
Note: Do not allow the server to fall over.
5. Unlock and remove the side cover (see “Removing the side cover” on page 43).
6. Remove any adapters that impede access to the battery.
7. Locate the battery on the system board (see “System-board internal connectors”
on page 28 for the location of the battery on the system board).
8. Remove the battery:
a. Use a finger to push the battery horizontally out of its socket, pushing it
away from the socket 1.
b. Lift and remove the battery from the socket 2.
9. Dispose of the battery as required by local ordinances or regulations.
Installing the battery
The following notes describe information that you must consider when replacing the
battery in the server.
v After you replace the battery, you must reconfigure the server and reset the
system date and time.
Chapter 5. Installing optional devices and replacing customer replaceable units 55