Filter
Top Products
Table 4. IDs for the four-bay 3.5-inch hot-swap drive models (continued)
Drive bay number ID
Drive bay 5 1
Drive bay 6 2
Drive bay 7 3
Table 5. IDs for the eight-bay 2.5-inch hot-swap models
Drive bay number ID
Drive bay 4 0
Drive bay 5 1
Drive bay 6 2
Drive bay 7 3
Drive bay 8 4
Drive bay 9 5
Drive bay 10 6
Drive bay 11 7
Power and signal cables for internal drives
The server uses cables to connect SATA attached, simple-swap SATA, hot-swap
SATA and hot-swap SAS devices to the power supply and to the system board.
(See “System-board internal connectors” on page 28 for the location of
system-board connectors.) Review the following information before connecting
power and signal cables to internal drives:
v The drives that are preinstalled in the server come with power and signal cables
attached. If you replace any drives, remember which cable is attached to which
drive.
v When you route a cable, make sure that it does not block the airflow to the rear
of the drives or over the microprocessor or DIMMs.
The following cables are provided:
v The DVD drive is attached to an ATA signal cable. The blue connector is
attached to the system board. The connector on the other end is attached to the
SATA device. The middle connector attaches to an optional optical device or tape
drive. A separate power cable provides power to the device from the system
board.
v Simple-swap SATA models: The simple-swap SATA models come with a
combination signal/power cable that connects to the connector on the system
board and the simple-swap SATA backplate to provide signal and power to the
simple-swap SATA drives. Connect the power connector on the split end of the
cable to the Hard disk drive backplane power connector on the system board
and connect the signal connector on the split end of the cable to the
Simple-swap SATA signal cable connector on the system board. On the other
end of the combination signal/power cable, connect a signal connector to each
drive bay signal connector on the simple-swap SATA backplate and connect a
power connector to each drive bay power connector on the simple-swap SATA
backplate.
v Hot-swap SAS or hot-swap SATA models:
78 ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide