Filter
Top Products
8. Install the new power supply assembly into the chassis so that the screw holes
in the new power supply assembly are aligned with the corresponding holes
in the rear of the chassis. Then, install the three screws to secure the new
power supply assembly in place.
Note: Use only screws provided by Lenovo.
9. Connect the new power supply assembly cables to all drives and to the 24-pin
power connector and 4-pin power connector on the system board. See
“Locating parts on the system board” on page 11.
10. Make sure that the cables are routed properly. See Figure 41 on page 47.
Figure 25. Installing the power supply assembly
Chapter 2. Installing or replacing hardware 33