Filter
Top Products
7. Position the new hard disk drive into the hard disk drive bay and align the
screw holes in the new hard disk drive with the corresponding holes in the
drive bay assembly. Then, hold the new hard disk drive from one side of the
drive bay assembly and install the four screws from the other side to secure the
new hard disk drive in place.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to “Completing the parts replacement” on
page 46.
Replacing the card reader
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide,goto:
http://www.lenovo.com/support
This section provides instructions on how to replace the card reader.
Note: The card reader is available only in some models.
To replace the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
Figure 35. Installing the hard disk drive
40 User Guide