Filter
Top Products
Installing the lower bezel ....................65
Removing the upper bezel....................66
Installing the upper bezel ....................67
Removing an adapter .....................68
Installing an adapter ......................69
Removing and installing internal drives ...............71
Removing a hot-swap power supply ................81
Installing a hot-swap power supply ................83
Removing a memory module...................84
Installing a memory module ...................85
Removing and replacing optional-service CRUs .............86
Removing the battery .....................86
Installing the battery ......................86
Removing the rear system fan ..................88
Installing the rear system fan...................89
Removing the hard disk drive fan assembly .............90
Installing the hard disk drive fan assembly ..............92
Removing the simple-swap backplate ...............93
Installing the simple-swap backplate ................95
Removing the SAS/SATA hard disk drive backplane ..........96
Installing the SAS/SATA hard disk drive backplane ...........97
Removing the front-panel assembly ................99
Installing the front-panel assembly ................100
Removing the front USB connector assembly ............100
Removing the rear adapter retention bracket ............101
Installing the rear adapter retention bracket .............102
Removing the front adapter-retention bracket ............102
Installing the front adapter-retention bracket .............103
Installing the front USB connector assembly.............103
Removing the hot-swap power supply cage .............104
Installing the hot-swap power supply cage .............105
Removing the mini-SAS/SATA controller ..............106
Installing the SAS/SATA controller ................107
Removing the optional mini-PCI-X enablement card ..........107
Installing the optional mini-PCI-X enablement card ..........108
Removing the RAID-MR10i SAS/SATA controller ...........109
Installing the RAID-MR10i SAS/SATA controller ...........110
Removing an IBM Remote Supervisor Adapter II SlimLine adapter ....112
Installing an IBM Remote Supervisor Adapter II SlimLine adapter .....113
Removing and replacing FRUs ..................115
Removing a non-hot-swap power supply ..............115
Installing a non-hot-swap power supply ..............117
Removing the microprocessor and fan sink .............118
Installing a microprocessor and fan sink ..............120
Removing the system board ..................123
Installing the system board ...................125
Chapter 5. Diagnostics .....................129
Diagnostic tools ........................129
POST ............................129
POST beep codes ......................130
No-beep symptoms
......................132
Error logs .........................133
POST error codes ......................135
Checkout procedure ......................145
About the checkout procedure ..................145
iv ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual