Filter
Top Products
1 Rear adapter retention bracket 4 Left side of the Front adapter
retention bracket
2 Expansion-slot screw 5 Right side of the Front adapter
retention bracket
3 Adapter
10. Install an expansion-slot screw at the rear of the adapter.
11. If you are installing a full-length adapter, press on the release lever on the
right side of the front adapter-retention bracket to release the retaining tab on
the left side of the bracket.
12. Connect required cables to the adapter. Route cables so that they do not block
the flow of air from the fans.
13. Reinstall the rear adapter-retention bracket; then, rotate the bracket to the
closed position.
Note: If any adapters in the server are large or have heavy cables attached to
them, you can remove the rear adapter-retention bracket and secure all
of the adapters with expansion-slot screws.
If
you have other devices to install or remove, do so now; otherwise, go to
“Completing the installation” on page 30.
Chapter 2. Installing optional devices 29