Lenovo T430 Tablet User Manual


 
Solution: Make sure that:
The cable is installed correctly.
The network cable must be securely connected both to the Ethernet connector of your computer and
to the RJ45 connector of the hub. The maximum allowable distance from the computer to hub is 100
meters. If the cable is connected and the distance is within acceptable limits but the problem persists, try
a different cable.
You are using the correct device driver.
1. Go to the Control Panel. Click Hardware and Sound Device Manager. If you are prompted for an
administrator password or conrmation, type the password or provide conrmation.
2. If the exclamation mark ! is displayed next to the adapter name under Network adapters, you
might not be using the correct driver or the driver might have been disabled. To update the driver,
right-click the highlighted adapter.
3. Click Update Driver Software, and then follow the instructions on the screen.
The switch port and the adapter have the same duplex setting.
If you congured the adapter for full duplex, make sure that the switch port also is congured for
full duplex. Setting the wrong duplex mode can degrade performance, cause data loss, or result in
lost connections.
You have installed all networking software that is necessary for your network environment.
Check with your LAN administrator for the necessary networking software.
Problem: The adapter stops working for no apparent reason.
Solution: The network driver les might be corrupt or missing. Update the driver by referring to the above
solution for the procedure to make sure that the correct device driver is installed.
Problem: If your computer is a Gigabit Ethernet model and you use a speed of 1000 Mbps, the connection
fails or errors occur.
Solution:
Use Category 5 wiring and make sure that the network cable is securely connected.
Connect to a 1000 BASE-T hub/switch (not 1000 BASE-X).
Problem: The Wake on LAN feature is not working.
Solution:
Make sure that Wake on LAN is enabled in ThinkPad Setup.
If it is, check with your LAN administrator for the necessary settings.
Problem: If your computer is a Gigabit Ethernet model, it cannot connect to the network at 1000 Mbps.
Instead, it connects at 100 Mbps.
Solution:
Try another cable.
Make sure that the link partner is set to auto-negotiate.
Make sure that the switch is 802.3ab-compliant (gigabit over copper).
A wireless LAN problem
Problem: You cannot connect to the network using the built-in wireless network card.
142 User Guide