Lexmark 5400 Series All in One Printer User Manual


 
3 Press or repeatedly until Print Photos appears.
4 Press .
5 Press or repeatedly until Print DPOF Selection appears.
6 Press Start Color or Start Black.
Using a PictBridge-enabled digital camera to control printing
photos
You can connect a PictBridge-enabled digital camera to the printer, and use the buttons on the camera to select and
print photos.
1 Insert one end of the USB cable into the camera.
Note: Use only the USB cable that came with the digital camera.
2 Insert the other end of the cable into the PictBridge port on the front of the printer.
Notes:
Make sure the PictBridge-enabled digital camera is set to the correct USB mode. For more information, see
the camera documentation.
The printer recognizes one active media device at a time. If you insert more than one media device, a message
appears on the display prompting you to designate the device you want the printer to recognize.
If the PictBridge connection is successful, the following appears on the printer display: PictBridge
camera detected. Press to change settings. If any other message appears, see “Error
messages” on page 115.
3 Follow the instructions in the camera documentation to select and print photos.
Note: If the printer is turned off while the camera is connected, you must disconnect and then reconnect the camera.
Working with photos
61