LG Electronics HCS6320 Network Router User Manual


 
206-4183
15
Network and Communication Setup
The HCS6320 feature card and the transcoder cards installed in the CodePlus card frame
contain several internal registers for different configuration options. This document describes
configuration options via a network or direct connection to the HCS6320.
Refer to the Installation & Setup Guide for HCS7720 transcoder cards for information on
performing configuration via a direct connection to the HCS7720 Service Port.
Note: Before you proceed with any additional configuration, the system (including
the feature card, transcoders, and satellite STBs) should be installed and
operating as described in the Installation and Setup sections in this document.
There are three options for communicating with the HCS6320.
• When the HCS6320 is connected to an IP network, you can use a standard Internet browser
to communicate with the HCS6320 via a graphical user interface (GUI).
• When the HCS6320 is connected to an IP network, you can also use Telnet to communicate
with the HCS6320 via a command line interface.
• To establish a direct connection to the HCS6320, connect a PC to the serial port on the
HCS6320 using the FTDI TTL-USB cable (P/N TTL-232R-5V-AJ). Plug the USB end of the
cable into an open USB port on your PC. If necessary, install the device driver. Plug the
other end of the cable into the Service Port jack on the HCS6320 front panel.
Using HyperTerminal or an equivalent terminal emulation program on the PC, configure the
serial port as follows:
Bits per second/baud = 115200
Data bits = 8
Parity = None
Stop bits = 1
Flow Control = None
Conguration options via web GUI are described on pages 16 to 29; conguration options
via command line are described on pages 30 to 47. For security and control purposes, some
options available from the command line menus are not available from the GUI.
Note: The default network setting for the HCS6320 is DHCP, in which case the server
assigns an IP address to the HCS6320. If necessary, consult the network administrator
to
obtain the
IP address that has been assigned to the HCS6320.
Note: If you want to connect the PC directly to the HCS6320 ETHERNET port using an
Ethernet crossover cable, in order to establish communication you must rst connect the PC
to the HCS6320 Service Port, and set the HCS6320’s IP address (see “Set the HCS6320 IP
Address” on page 33). The HCS6320’s IP address must be on the same subnet as the PC’s IP
address.