Filter
Top Products
16
206-4183
Caution: Do NOT initiate simultaneous menu sessions to run commands. Doing
so will interfere with active processes and may corrupt the system configuration
and/or cause the HCS6320 card to cease normal operation.
Access the CodePlus Transcoder Series Web GUI
Note: The HCS6320 must be connected to an IP network for GUI access. See “Network and
Communication Setup” on page 15 for further information.
1. Launch a web browser, and type http://ipaddress in the browser’s address bar, where
ipaddress is the IP address of the HCS6320 card. Then, press Enter.
The CodePlus™ Transcoder Series Conguration Homepage provides access to Controller
(HCS6320), Transcoder, and Satellite STB menus:
2. Click the appropriate link or tab to access the desired configuration options/settings.
The following sections provide detailed information on the conguration settings and
commands. Note that menu options may vary from the examples shown in this document,
depending on the HCS6320 rmware version.
When you have completed your activities in the web GUI, you can simply close your
browser.
Controller Menu Commands
The following subsections describe how to access and use the Controller Menu commands.
Access the Controller Menu
1. Access the CodePlus Transcoder Series web GUI as described above.
2. With the Homepage on display, click on the Controller menu tab or link.
The Controller Menu (see example on following page) enables you to view and modify
HCS6320 conguration settings and also enables you to view transcoder data. In addition,
the Controller Menu enables you to update HCS6320 and transcoder card rmware.
Conguration Options via GUI