Filter
Top Products
30
206-4183
Caution: Do NOT initiate simultaneous menu sessions to run commands. Doing
so will interfere with active processes and may corrupt the system configuration
and/or cause the HCS6320 card to cease normal operation.
Access the HCS6320 Main Menu
Note: The HCS6320 must be connected to an IP network for Telnet access. For direct access
to the HCS6320 Service Port, use the FTDI TTL-USB cable (P/N TTL-232R-5V-AJ). See also
“Network and Communication Setup” on page 15 for further information.
1. Establish communication with the HCS6320 using Telnet or via a direct connection to the
HCS6320 Service Port.
2. Once communication is established, press Enter to refresh the menu display in the terminal.
You now have access to the HCS6320 configuration Main Menu (see example below).
3. At the
[Main] Command >
prompt, type the desired menu command and press Enter.
Note: You can always press Enter at the
[Main] Command >
prompt to display the
HCS6320 Main Menu. Main Menu options may vary from the example shown, depending on
the HCS6320 rmware version.
The following sections describe the configuration commands.
Example: HCS6320 Main Menu
------------------------------------------
Main Menu (Copyright 2012 - LGE USA)
------------------------------------------
info System Information
rf Set RF Channels
mrf Print RF Channels Map
list List Cards
card Card Menu
xrst External Card Reset
setip Set Up IP Address
pi Install PI Key On All Cards
pr Reload PI Key on All Cards
upd Update Firmware
bits Read MUX Bitrates
rawbits Read Bitrates at Backplane Connector
crosspt Configure Card Number to Channel Assignment
rstpwd Reset Password (for Reload PI Key on Web UI)
[Main] Command >
Conguration Options via Command Line