LG Electronics HCS6320 Network Router User Manual


 
46
206-4183
(Continued on next page)
Conguration Options via Command Line (Cont.)
Read STB Update Parameters
At the
[Satellite (#)] Command >
prompt, type getupd and press Enter to display the
current STB update status, for example:
STB Update is scheduled to begin in 12 hours 0 minutes
with duration 25 minutes
or
STB Update is not scheduled.
or
STB Update is in progress.
It will end in 1 minutes (total duration 25 minutes).
Set STB Update Parameters
1. At the
[Satellite (#)] Command >
prompt, type setupd and press Enter.
2. At the
Change STB Update setting (y/n)?
prompt, either:
• Type y and press Enter to modify the current STB software update parameters.
• Type n and press Enter to return to the Satellite Receiver Menu without modifying the
STB software update parameters.
3. At the
Enable updates (y/n)?
prompt, either:
• Type y and press Enter to enable and congure STB software update parameters. The
system will initiate a series of prompts that enable you to specify the maintenance
window for the update. Continue with step 4.
• Type n and press Enter to disable the STB software update. Then, press Enter again to
return to the
Command >
prompt.
4. At each of the following prompts, type the number of hours and minutes to delay before
the STB software update is initiated, as well as the desired duration (in minutes) for the
update window. Note that all three of these elds require numerical values. Press Enter
after each entry.
If applicable, you can also press Enter at each prompt to accept the default value in
square brackets.
Enter the number of hours to delay before starting [12]
Enter the number of minutes to delay before starting [0]
Enter the maintenance window duration in minutes [25]
Note: The system will not allow a maintenance window that is less than 10 minutes or over
four hours. The default value (25 minutes) is the minimum time span typically recommended
for an update. It is also recommended that you schedule a maintenance window during a
time when the STB is not likely to be in use.