Filter
Top Products
36 Plasma Monitor
External Control Device Setup
23. ISM Method (Command2:p)
G To avoid having a fixed image remain on screen.
Transmission
Data 0: Normal
1: White wash
2: Orbiter
3: Inversion
[j][p][ ][Set ID][ ][Data][Cr]
Acknowledgement
[p][ ][Set ID][ ][OK][Data][x]
26. Auto Configure (Command2:u)
G To adjust picture position and minimize image shaking
automatically. Auto Configure only works in RGB-PC
mode.
Transmission
Data 1
• Refer to ‘Real data mapping1’. See page 34.
[j][u][ ][Set ID][ ][Data][Cr]
Acknowledgement
[u][ ][Set ID][ ][OK][Data][x]
25. Picture Size Setting for DW mode
(Command2:t)
G To adjust main picture size in DW mode.
Transmission
Data Min: 0 ~ Max: 30
• Refer to ‘Real data mapping1’. See page 34.
[j][t][ ][Set ID][ ][Data][Cr]
Acknowledgement
[t][ ][Set ID][ ][OK][Data][x]
21. PIP Input Select (Command2:y)
G To select input source for sub picture in PIP mode.
Transmission
[k][y][ ][Set ID][ ][Data][Cr]
Acknowledgement
[y][ ][Set ID][ ][OK][Data][x]
22. Abnormal State (Command2:z)
G To recognize an abnormal state.
Transmission
Data 0: Power on(signal)
1: Power on(No signal)
2: Remote control off
3: Sleep time off
4: RS-232C off
5: 5V monitor off
6: AC detect off
7: Fan Alarm off
8: Off timer off
9: No signal off
a: Connection Detect off
[k][z][ ][Set ID][ ][FF][Cr]
Acknowledgement
[z][ ][Set ID][ ][OK][Data][x]
Data FF:Read
Data 1 : Video1
2 : Video2
3 : Component1
4 : Component2
5 : RGB
6 : DVI
7 : Video3
8 : Video4
9 : HDMI
Data 1 : Video1
2 : Video2
3 : Component1
4 : Component2
5 : RGB
6 : DVI
7 : Video3
8 : Video4
9 : HDMI
Data 0: Normal
1: White wash
2: Orbiter
3: Inversion
24. Low Power (Command2:q)
G To control the low power function on/off.
Transmission
Data 0: Low power off
1: Low power on
[j][q][ ][Set ID][ ][Data][Cr]
Acknowledgement
[q][ ][Set ID][ ][OK][Data][x]
Data 0: Low power off
1: Low power on
Data Min: 0 ~ Max: 30
Data 1
27. Key (Command2:c)
G To adjust Key code for IR remote control.
Transmission
Data Key code : Refer to See page 38.
[m][c][ ][Set ID][ ][Data][Cr]
Acknowledgement
[c][ ][Set ID][ ][OK][Data][x]
* If you do not press any button within 2 hours after the monitor turns
on with the On Timer function, the monitor will automatically revert to
standby mode.