Magma PE6R4-I Computer Hardware User Manual


 
(6 locations)
Quick Installation Guide
Magma
PE6R4-I
© 2008 MissionTechnology Group,Incorporated,DBA Magma
This publication is protected by Federal Copyright Law,with all rights reserved. No part of this publication may be copied, photocopied,
r
eproduced, stored in a retrieval system, translated, transmitted or transcribed, in any form or by any means manual, electric, electronic,
electro-magnetic,mechanical,optical or otherwise,in whole or in part without prior written consent from MissionTechnology Group,Inc..
Limitation of Liability
I
nformation presented by Magma in this manual is believed to be accurate and reliable.However,Magma assumes no responsibility for its use.
No license is granted by implication or otherwise to any rights of Magma.
T
rademark References
Trademarks and registered trademarks are proprietary to their respective manufacturers.
P
roduct specifications and prices are subject to change without notice. 09-09943-02-A
Magma
9
918 Via Pasar, San Diego, CA 92126, USA
Phone (800) 285-8990 US, (858) 530-2511 Fax (858) 530-2733
w
ww.magma.com
Package Contents
IMPORTANT
I
mportant safety,ESD,and other information on how to use MGMA PE6R4-I are provided in the User Guide.
This manual is available online for a download at www.magma.com/support/manuals.
E
lectrostatic Dischar ge Warni ng (ESD)
Perform installation and service of circuit cards with semiconductor devices at an ESD work station and follow
p
roper ESD procedure to reduce the risk of damage to components
(1) Magma PE6R4-I chassis
(
1) PCIe Cable x8 to x4
(1) Magma PCIe Host Card
(
1) Power Cord
!
1
Install PCI Express Host card and connect cables
Install the Magma PCI Express Host Card into an available PCI Express slot in your computer.
2
Open Enclosure
Remove the 6 screws that retain the top cover of the expansion chassis.
Slide the cover
backwards and upwards.
3
Install PCI or PCI-X cards
Remove PCI filler brackets for the expansion slot you wish to use in the chassis.
Install peripheral PCI or PCI-X card into slot connector and secure with
retaining screw.
Repeat the process for all other PCI or PCI-X peripherals you wish to
install in the chassis.
Secure it with retaining screw.
Connect the x8 side of the iPass cable to the host card.
Power on PE6R4-I
Turn the power on using
the power switch on the
front of the chassis.Verify
that the green LED above
the power switch is on.
4
x4
x8
Connect the x4 side of the
iPass cable to the back of the
PE6R4-I chassis along with
the chassis power cord.
HOST COMPUTER
HOST COMPUTER
x8 Connector
PE6R4-I
x4 Connector