Filter
Top Products
DS33R11 Ethernet Mapper with Integrated T1/E1/J1 Transceiver
164 of 344
Register Name:
LI.RPPSRIE
Register Description:
Receive Packet Processor Status Register Interrupt Enable
Register Address:
106h
Bit # 7 6 5 4 3 2 1 0
Name REPIE RAPIE RIPDIE RSPDIE RLPDIE REPCIE RAPCIE RSPCIE
Default 0 0 0 0 0 0 0 0
Bit 7: Receive FCS Errored Packet Interrupt Enable (REPIE) This bit enables an interrupt if the REPL bit in the
LI.RPPSRL register is set.
0 = interrupt disabled
1 = interrupt enabled
Bit 6: Receive Aborted Packet Interrupt Enable (RAPIE) This bit enables an interrupt if the RAPL bit in the
LI.RPPSRL register is set.
0 = interrupt disabled
1 = interrupt enabled
Bit 5: Receive Invalid Packet Detected Interrupt Enable (RIPDIE) This bit enables an interrupt if the RIPDL bit in
the
LI.RPPSRL register is set.
0 = interrupt disabled
1 = interrupt enabled
Bit 4: Receive Small Packet Detected Interrupt Enable (RSPDIE) This bit enables an interrupt if the RSPDL bit
in the
LI.RPPSRL register is set.
0 = interrupt disabled
1 = interrupt enabled
Bit 3: Receive Large Packet Detected Interrupt Enable (RLPDIE) This bit enables an interrupt if the RLPDL bit
in the
LI.RPPSRL register is set.
0 = interrupt disabled
1 = interrupt enabled
Bit 2: Receive FCS Errored Packet Count Interrupt Enable (REPCIE) This bit enables an interrupt if the REPCL
bit in the
LI.RPPSRL register is set. Must be set low when the packets do not have an FCS appended.
0 = interrupt disabled
1 = interrupt enabled
Bit 1: Receive Aborted Packet Count Interrupt Enable (RAPCIE) This bit enables an interrupt if the RAPCL bit
in the
LI.RPPSRL register is set.
0 = interrupt disabled
1 = interrupt enabled
Bit 0: Receive Size Violation Packet Count Interrupt Enable (RSPCIE) This bit enables an interrupt if the
RSPCL bit in the
LI.RPPSRL register is set.
0 = interrupt disabled
1 = interrupt enabled