Filter
Top Products
Figure : Outline and Mounting for 2kVA
2- 1B
The side mounting brackets can be positioned for either a 19
inch, 23 inch, or 25 inch rack. The Inverter can also be
mounted either flush with the front panel or at the chassis
midpoint. Prior to mounting the Inverter in the rack,
determine the position of all input and output wiring.
NOTE
Input and output conductors must be sized for the maximum current
as shown in Table 2-1 and otherwise be in compliance with applica-
ble electrical codes. Be sure all connections are fully tightened.
D.C. input terminals can accommodate wire size up to one "0" gauge
wire.
2.5.2 Mounting And
Wiring Access
86-153061-00 2 — 3Installation and Operation
Owner’s Manual