Filter
Top Products
Parameter description:
These trap functions are as they describe. The special one is Module Swap. It means that when the switch
detects a module with the different module ID to be inserted, the switch treats it as Module swapped. The traps
that the switch supports are listed below.
y STP: STP Topology Change, STP Disabled, STP Enabled
y LACP: LACP Disabled, LACP Enabled, LACP Member Added, LACP Port Failure
y GVRP: GVRP Disabled, GVRP Enabled
y VLAN: VLAN Disabled, Port-based VLAN Enable, Tag-based VLAN, Enable, Metro-mode VLAN
Enabled, Double-tag VLAN Enabled
y Module Swap: SEP Inserted, SEP Removed, Dual-media Swapped
y Trap: Cold Start, Warm Start, Link Down, Link Up, Authentication Failure, User login, User logout
3.15.2 Email/SMS
Alarm configuration is used to configure the persons who should receive the alarm message via either email or
SMS, or both. It depends on your settings. An email address or a mobile phone number has to be set in the
web page of alarm configuration. Then, user can read the trap information from the email or the mobile phone.
This function provides 6 email addresses and 6 mobile phone numbers at most. The 24 different trap events
will be sent out to SNMP Manager when trap event occurs. After ticking trap events, you can fill in your desired
email addresses and mobile phone numbers. Then, please click <Apply> button to complete the alarm
configuration. It will take effect in a few seconds.
Note: SMS may not work in your mobile phone system. It is customized for different systems.
Parameter description:
y Email:
y Mail Server: the IP address of the server transferring your email.
51