Filter
Top Products
Command Line Interface
4-238
4
Example
In the following example, the device is assigned an address in VLAN 1.
Related Commands
ip dhcp restart client (4-127)
ip default-gateway
This command specifies the default gateway for destinations not
found in the local
routing tables. Use the no form to remove a default gateway.
Syntax
ip default-gateway gateway
no ip default-gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Command Usage
• The gateway specified in this command is only valid if routing is disabled with
the no ip routing command. If IP routing is disabled, you must define a
gateway if the target device is located in a different subnet.
• If routing is enabled, you must define the gateway with the ip route
command.
Example
The following example defines a default gateway for this device:
Related Commands
show ip redirects (4-239)
ip routing (4-244)
ip route (4-245)
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#
Console(config)#ip default-gateway 10.1.1.254
Console(config)#