Filter
Top Products
EN-10
Setting up your projector
Setting up the screen
Install the screen perpendicularly to the projector. If the screen can not be installed in such a way, adjust the
projection angle of the projector. (See below.)
Install the screen and projector so that the projector’s lens is placed at the same height and horizontal position of
the screen center.
Do not install the screen where it is exposed to direct sunlight or lighting. Light directly refl ecting on the screen
makes the projected images washed-out and hard to view.
SCREEN SIZE
You can keep the image display area within the screen by setting SCREEN SIZE in the ADVANCED MENU of IMAGE
menu according to the size of the actual screen.
When setting SCREEN SIZE to CINEMA SCOPE(2.35:1):
CinemaScope size movies are projected in the full screen.
Set ASPECT in the FEATURE menu to 16:9 when displaying Vista-size images. In this case, they are squeezed
horizontally.
When ASPECT in the FEATURE menu is set to AUTO and 480i/p, 576i/p, 720p, or 1080i signal is input, the part
for displaying subtitles is not projected. Then, set SCREEN SIZE to 16:9 and adjust the image position using
VERTICAL LOCATION in the ADVANCED MENU of the IMAGE menu. (To display the menu on the screen, adjust
SHUTTER(U) in the SIGNAL - USER menu to position the menu.)
Basic setup
Determine the distance from the screen to the projector according to the size of the images to be projected. (See
page 12.)
W
A
A=B
B
Depending on the installation conditions, warm air that is emitted from the exhaust vents may fl ow into the intake
vent, causing the projector to display “TEMPERATURE!!” and then stop projecting images.
•
•
•
•
•
•
LENS SHIFT button
To adjust the positions of the projector and the
screen, use LENS SHIFT button.
Press the LENS SHIFT button.
Press the S, T, W or X button to move the
image position.
Every time the T button is pressed, the
image moves down.
Every time the S button is pressed, the
image moves up.
Every time the X button is pressed, the image
moves to the right.
Every time the W button is pressed, the image
moves to the left.
When you hold down S, T buttons for 2
seconds or longer, the displayed image moves
fast in the corresponding directions.
Be careful not to be caught in the opening in the
lens while the lens is moving.
When the lens is vertically shifted by a large
amount, color separation may occur.
1.
2.
•
•
•
•
•
•
•
Adjusting the projection angle
This projector is provided with two feet for adjusting
the projection angle on the bottom surface. Adjust
the projection angle depending on the position of
the projector.
Adjustment of the projection angle
For the best projection, project images on a
fl at screen installed at 90 degrees to the fl oor.
If necessary, tilt the projector using the two
adjustment feet on the bottom of the projector.
Adjustment feet
Screen
Tilt up the projector to the appropriate angle.
Press the foot adjustment buttons next to the
adjustment feet, and the adjustment feet will
come out.
Release the buttons to lock the adjustment feet
to that position.
Rotate the adjustment feet for fi ne adjustment.
After using the projector:
Put the adjustment feet back into the projector
by pressing the foot adjustment buttons.
If necessary, rotate the adjustment feet for fi ne
adjustment.
1.
2.
3.
4.
5.
•