Motion Computing J3400 Personal Computer User Manual


 
J3400 Work Anywhere Kit
Moun ng Pin Installa on
Installa on de montage des points d’a aches
Anbringen des Befes gungss einheit
© 2009 Motion Computing, Inc. All rights reserved. P/N: 024-02-0217-A00
Gap
Écart
Lücke
:
É
É
L
L
Wrong
Mauvais
Falsch
No Gap
Pas d’écart
Nein Lücke
;
Correct
Correct
Korrigieren Sie
P
P
N
If there is a gap between the pin and the tablet, it is not seated correctly. Loosen the screw and rotate the pin about a quarter turn so
the oval pin collar will stop and seat in the oval recess and not turn further. Re-tighten the screw with the pin in the correct position.
S’il y a un écart entre le point d’attache de la bandoulière et la tablette, celui-ci n’est pas xé correctement.
Desserrez la vis et faites tourner l’attache d’un quart de tour a n que le col ovale de l’attache se place
correctement et se bloque dans l’emplacement ovale à l’intérieur de la tablette. Les deux pièces doivent
s’emboîter, sans permettre de faire tourner la pièce plus loin. Une fois l’attache ajustée,
resserrez la vis.
Ist ein Abstand zwischen der Schraube und dem Tablet auszumachen, wurde falsch montiert.
Lösen Sie die Schraube mit einer Vierteldrehung bis der Schraubenkopf korrekt in der ovalen
Vertiefung zu liegen kommt. Ziehen Sie dann die Schraube in der korrekten Position an.