Filter
Top Products
MRV Communications, Inc. – Installation Manual
64
Figure E.3: Active Transmitters (Shown Darkened).
Bench Test for TS700 and TS800 series with JAH-L
The Aiming head of the TS700 and TS800 series was changed from AD-700
to JAH-L.
Therefore the TereScopes are delivered to the clients not mounted on the
Aiming head. In this case, when the back door is opened and secured in its
place, it hangs over the TereScope basis and the TereScope can’t stand straight
and leans on the door, which can damage the door’s hinges.
Therefore there are two ways to perform the Bench test, as can be seen on the
following figures.
The first way is to mount the TereScope on its Aiming head and do all the
tests before installation with the alignment head.
Figure E.2b: Bench Test setup drawing
for 10” TS model.
Note that one device is higher than the
other and shifted over to the side so that
only one transmitter from each device is
facing opposite the other device’s receiver.
Telescopes
Figure E.4: Bench test with TereScopes mounted on the Aiming Head (JAH-L.)
Rear Door fixed
T
he Rear Door
hangs over the
T
ereSco
p
e basis
J
AH-L