Filter
Top Products
0910389
02-02-09
Section 78
In order to consistently bring you the highest quality, full featured products, we reserve the right to change our specifications and designs at any time.
MURPHY, the Murphy logo, MurphyLink
™
and PowerView
™
are registered and/or common law trademarks of Murphy Industries, Inc. This document,
including textual matter and illustrations, is copyright protected by Murphy Industries, Inc., with all rights reserved. (c) 2009 Murphy Industries, Inc.
PVS-5 Power Supply
Features
• Provides 5 Volt power supply to PVM gages
• Capable of supplying power to a maximum of
6 PVM gages
• Enables PVM gage compatibility with existing
MurphyLink products
• Easy mounting and installation
External power is required to make the PVM gage line compatible with existing MurphyLink products, i.e. PV1000,
Cascade, iGUARD and eGUARD. The PVS-5 power supply device supplies 5 Volts of external power and load
dump protection for up to 6 PVM gages. The maximum length of the power and data connection between gages is
0.5meters (8.5 meters total).
The unit may be installed inside a panel or behind a dash.
Product Dimensions
Wiring Diagram
The pin out information for the 4 pin connector is shown below.
Mating Connector
– Tyco Electronics AMP Mini
Universal Mate-N-Lok Plug Housing 4 Position,
AMP P/N 172338-1
Murphy P/N 00-00-6935