Filter
Top Products
Getting Started 1-19
! Configure the host PC's IP address on the MobilePro as follows:
1.
Tap Start, Settings, Control Panel, and double tap the network
icon.
2.
Highlight NE2000 Compatible Ethernet Driver and select the
Properties button.
3.
In the IP address tab, select (place a dot beside) “Obtain an IP
address via DHCP.”
4.
Select the Name Servers tab and enter the host PC's IP address in
the “Primary WINS” field.
To identify the host PC's IP address, run an IP config utility. In
Windows 95, 98, and 2000, run Win IP Config. In Windows NT,
run IP Config. If you need assistance, see your network
administrator.
Installing ActiveSync
Follow these steps to install Microsoft ActiveSync for synchronization
with Microsoft Outlook. The installation sequence may vary depending
upon the Microsoft components installed on your host PC.
Note
If your host PC uses the Windows NT operating system, you
must install Windows NT Networking before installing Microsoft ActiveSync
to your host PC.
1.
Insert the Microsoft ActiveSync CD in the CD-ROM reader of your
host PC.
! If auto insert is enabled on your host PC, the setup window
appears.
! If auto insert is not enabled, go to Start, Run, browse for the
CD-ROM drive, and run the setup.exe file.
2.
Click Next to start the Setup wizard.
The Selection Installation folder appears.
3.
Click Next to accept the default installation folder or modify the
folder destination and click Next.