Filter
Top Products
English-5
English
4. To prevent the LCD Monitor from falling
down
Fasten the LCD monitor to a wall using a cord or chain which
is sufficient to support the weight of the LCD monitor (approx.
LCD3210 17.0kg).
Before moving the LCD monitor, the cord or chain should be
removed.
Attaching LCD Options
You can attach mounting accessories to the LCD monitor in one
of the following two ways:
1. In the upright position
2. Lay the screen face down
To avoid damaging the screen face, place the protective sheet on the
table underneath the LCD. The protective sheet was wrapped around
the LCD in the original packaging. Make sure there is nothing on
the table that can damage the monitor.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. For proper installation it is strongly
recommended to use a trained, NEC authorized service person.
Failure to follow NEC standard mounting procedures could result in
damage to the equipment or injury to the user or installer. Product
warranty does not cover damage caused by improper installation.
Failure to follow these recommendations could result in voiding
your warranty.
When using mounting accessories other than NEC compliant and
approved, they must comply with the VESA-compatible mounting
method. NEC strongly recommends using screws M6 size and 10mm
in length. If using screws longer than 10mm, check the depth of the
hole. (Recommended Fasten Force: 470 - 550N•cm)
NEC recommends using mounting interface that comply with UL1678
standard in North America.
5. To prevent use of Main Power Switch
To prevent the use of the Main Power Switch, if desired, please attach
the Main Power Switch cover which is included as an accessory.
NOTE: With the main power switch cover in place, the main power
switch can not be turned off. To turn the power off, remove the main
power switch cover and turn off the switch, or remove the power
cord from the AC Inlet at the back of the monitor.
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram below.
Protective Sheet
Tabletop Stand
Table
358mm
Clamper
Cord or Chain
Screw
Main switch cover
Screw