Rev.2 - YML630 www.netcomm.com.au
Cable/DSL Firewall Router Page 15
- If yes, go to step 6.
- If no, click the “Add” button.
3. Double-click “Protocol” on the Select Network Component Type or highlight “Protocol”
then click “Add”.
4. Highlight “Microsoft” under the list of manufacturers.
Double-click “TCP/IP” from the list on the right or highlight “TCP/IP” then click “OK” to
install TCP/IP.
5. After a few seconds, you will be brought back to the Network window. The TCP/IP
Protocol should now be on the list of installed network components (refer to point 2).
6. Click the “Properties” button.