Filter
Top Products
NB712 / NB714 User Guide 89
YML829 Rev1
14.10 Write
Any changes to the router configuration must be written to EPROM using the write command and the router
needs to be rebooted for the changes to take affect.
Move cursor to “ >> “ to write and press enter.
----------------------------------------------------------------------
Command: write <CR>
Message: Please input the following information.
Are you sure? (y/n): y
----------------------------------------------------------------------
14.11 Reboot
To reboot the router, use reboot command. Move cursor to “ >> “ to write and press enter.
----------------------------------------------------------------------
Command: reboot <CR>
Message: Please input the following information.
Do you want to reboot? (y/n): y
----------------------------------------------------------------------
14.12 Ping
Ping command will be used to test the connection of the router. Move cursor “ >> “ to ping and press enter.
----------------------------------------------------------------------
Command: ping <ip> [1~65534|-t] [1~1999]
Message: Please input the following information.
IP address <IP> : 10.0.0.1
Number of ping request packets to send (TAB select): -t
Data size [1~1999]: 32
----------------------------------------------------------------------
There are 3 types of number of ping request packet to send, default, 1~65534 and –t. Default will send 4 packet
and –t continuous packet until you key in Ctrl+c to stop.
14.13 Administration
You can modify the user profile, telnet access, SNMP (Sample Network Management Protocol), supervisor
information and SNTP (Simple Network Time Protocol) in admin. The route is enable ==> admin.
For configuration the parameters, move the cursor “ >> “ to admin and press enter.
>> user Manage user profile
security Setup system security
snmp Configure SNMP parameter
passwd Change supervisor password
id Change supervisor ID
sntp Configure time synchronization