Filter
Top Products
ReadyNAS 2100 User Manual
Optimizing Performance and Maintaining the System 5-13
v1.1, June 2009
Use the OS REINSTALL Option to Re-install the Firmware
To re-install the RAIDiator firmware on the ReadyNAS while leaving the data volume intact,
follow these steps.
1. Power off the device.
2. While using a paper clip or push pin to press in the SYS switch, power on the unit. Wait for up
to 30 seconds for the reset menu on the front to display, then release the reset switch.
The LEDs will indicate the boot menu is active.
3. Push the Backup button on the front panel three times to scroll through the menu to the OS
Reinstall option (USB LED off, Disk 1 LED off, Disk 2 LED off, Disk 3 LED on, Disk 4 LED
off).
4. Press the SYS button once to confirm the menu selection and proceed with that option.
The system will reboot reset to the factory default settings.
Figure 5-13
Figure 5-14
Figure 5-15
Off Off Off On Off