Filter
Top Products
Installation Guide
NETGEAR, the NETGEAR logo, and Connect with Innovation are
trademarks and/or registered trademarks of NETGEAR, Inc. and/
or its subsidiaries in the United States and/or other countries.
Information is subject to change without notice. © NETGEAR,
Inc. All rights reserved.
December 2013
NETGEAR, Inc.
350 East Plumeria Drive, San Jose, CA 95134 USA
AC327U 3G USB Modem
Insert a MicroSD Card
You can also insert a microSD card into the USB modem for mass storage.
To insert a microSD card into the USB modem:
1. Slide the back cover off the USB modem.
2. Insert a microSD card into the corresponding card slot in the USB modem.
3. Slide the back cover back onto the USB modem.
Support
After installing your device, locate the serial number on the label of your product
and use it to register your product at https://my.netgear.com.
You must register your product before you can use NETGEAR telephone
support. NETGEAR recommends registering your product through the
NETGEAR website.
For product updates and web support, visit http://support.netgear.com.
NETGEAR recommends that you use only the official NETGEAR support
resources.
You can get the user manual online at http://downloadcenter.netgear.com.
For the current EU Declaration of Conformity, visit
http://support.netgear.com/app/answers/detail/a_id/11621/.
For regulatory compliance information, visit
http://www.netgear.com/about/regulatory/. See the regulatory compliance
document before connecting the power supply.
Installation
Thank you for purchasing the AC327U 3G USB Modem. The dongle allows you
to connect your computer to the Internet using a high-speed 3G network.
Insert a SIM Card
Before you can set up the USB modem, you must insert a SIM card into the
USB modem.
To insert a SIM card into the USB modem:
1. Slide the back cover off the USB modem.
2. Insert a SIM card into the corresponding card slot in the USB modem.
3. Slide the back cover back onto the USB modem.
Set Up the Dongle
To set up the dongle, install the NETGEAR
®
Aircard
®
Mobile Broadband genie
®
on your computer using the Setup Wizard that is already installed in the USB
modem.
To install the NETGEAR Aircard Mobile Broadband genie:
1. Insert the USB modem into the USB port on a computer.
The Setup Wizard displays.
Note: If the Setup Wizard does not display, browse the files on the USB
modem and double-click AutoRun.exe.
2. Follow the onscreen instructions.