Filter
Top Products
ReadyNAS NVX Business Edition User Manual
6-6 Managing Levels of Service
v1.1, February 2009
3. OS Reinstall: While keeping the data volume in tact, re-install the RAIDiator firmware on the
ReadyNAS, reset the admin password and change the DHCP assignment to DHCP client. This
is helpful if you have lost your admin password and want to set it back to default, if errors in
your network settings has made it impossible to connect to the ReadyNAS, or if you suspect
that the operating system on your disk may somehow be corrupt.
4. Tech Support: Enable the remote diagnostic function.
5. Skip Volume Check: Boot the system but bypass the volume check.
6. Memory Test: Perform a memory diagnostic.
Typically, if you find that a configuration change makes the unit inaccessible, you can use option
(3) to set the unit back to a factory default state.
Use the OS REINSTALL Option to Re-install the Firmware
To Re-install the RAIDiator firmware on the ReadyNAS without touching the data volume, follow
these steps.
1. Power off the device.
2. While using a paper clip or push pin to press in the reset switch, power on the unit, wait for the
OLED reset menu on the front to display, then release the reset switch.
The OLED will display the reset menu.
Tip: If possible, use the configuration backup (see “Configuration Backup” on
page 2-34) to save your configuration so that if you have to reset the unit to its
factory default settings, you can simply restore all your settings from the
configuration backup.
Figure 6-8