Technical Notes and Index
F6
Caring for the Camera
Cleaning
Do not use volatile organic solvents such as alcohol or thinner, chemical
detergents, anticorrosive agents, or anti-fogging agents.
Storage
Remove the battery if the camera will not be used for an extended period. Do not
store the camera with naphtha or camphor moth balls, or in any of the following
locations:
• Next to equipment that produces strong electromagnetic fields, such as
televisions or radios
• Exposed to temperatures below –10°C (14°F) or above 50°C (122°F)
• Places that are poorly ventilated or subject to humidity of over 60%
To prevent mold or mildew, take the camera out of storage at least once a month.
Turn the camera on and release the shutter a few times before putting the camera
away again.
Be sure to read and follow the warnings given in “The Battery” (F3) of “Caring for
the Products” to store the battery.
Lens/
viewfinder
Avoid touching glass parts with your fingers. Remove dust or lint with a blower
(typically a small device with a rubber bulb attached to one end that is
pumped to produce a stream of air out the other end). To remove fingerprints,
oily substances, or other stains that cannot be removed with a blower, carefully
wipe the lens with a dry soft cloth or eyewear cleaning cloth, using a spiral
motion that starts at the center of the lens and working toward the edges. Do
not wipe the lens forcibly or with a hard material. Failure to observe this
precaution could result in damage or trouble. If this fails, clean the lens using a
cloth lightly dampened with commercial lens cleaner.
Monitor
Remove dust or lint with a blower. To remove fingerprints, oily substances or
other stains, carefully wipe the monitor with a dry soft cloth or eyewear
cleaning cloth. Do not wipe the monitor forcibly or with a hard material. Failure
to observe this precaution could result in damage or trouble.
Body
Use a blower to remove dust, dirt, or sand, then wipe gently with a soft, dry
cloth. After using the camera at the beach or other sandy or dusty
environment, wipe off any sand, dust, or salt with a dry cloth lightly dampened
with fresh water and dry thoroughly. Note that foreign matter inside the
camera could cause damage not covered by the warranty.