Filter
Top Products
Ethernet Base ModulePassport 4400 Hardware Installation Manual
3-10
Removing and Installing SIMMs
Instructions for removing and installation are the same for the following
SIMMs:
• 16 Mbyte Flash Memory SIMM
• 16 Mbyte DRAM SIMM
• Data Compression SIMM
Follow the procedure below to remove a SIMM in the Passport unit:
1. Gently push out the connector locking flanges located at each side of the
slot housing the SIMM.
2. Move the SIMM to a vertical position.
3. Lift up the SIMM.
Follow the procedure below to install or replace a SIMM in the Passport unit.
1. Insert the SIMM into the connector.
2. Gently push down and the back on the SIMM.
3. The SIMM will “click” into the connector locking flanges.
Warning:
!
Do not attempt to remove or install any SIMM while power is
connected to the Passport unit. Be sure to disconnect the unit
from the power source.
2.
1.
3.
1.
2. 3.
“CLICK”
“CLICK”