Filter
Top Products
CX2032 MFP User’s Guide Maintenance
119
5. Locate the two fasteners (5) at each side of the belt and the
lifting bar (6) at the front end.
Transfer belt - unlock.eps Transfer
belt - out.eps
6. Turn the two fasteners 90° to the left. This will release the belt
from the MFP chassis.
7. Pull the lifting bar (6) upwards so that belt tilts up towards the
front, and withdraw the belt unit from the MFP.
8. Lower the new belt unit into place, with the lifting bar at the front
and the drive gear towards the rear of the MFP. Locate the drive
gear into the gear inside the printer by the rear left corner of the
unit, and lower the belt unit flat inside the MFP.
9. Turn the two fasteners (5) 90° to the right until they lock. This
will secure the belt unit in place.
10. Replace the four image drums, complete with their toner
cartridges, into the printer in the same sequence as they came
out: cyan (nearest the rear), magenta, yellow and black (nearest
the front).
11. Close the top cover and press down firmly at both sides so that
the cover latches closed.
5
5
6