Filter
Top Products
MENU FUNCTIONS > 153
NETWORK MENU
This menu controls the operation of the printer’s 10Base-T/100Base-
TX network interface.
NETWORK MENU
Item Settings Explanation
TCP/IP ENABLE / DISABLE Enables or disables this network protocol.
NETBEUI ENABLE / DISABLE Enables or disables this network protocol.
NETWARE ENABLE / DISABLE Enables or disables this network protocol.
ETHERTALK ENABLE / DISABLE Enables or disables this network protocol.
FRAME TYPE AUTO / 802.2 /
802.3 / ETHERNET
II / SNAP
Selects the Ethernet MAC layer frame type.
IP ADDRESS SET AUTO / MANUAL Specifies whether IP address allocation is
automatic (DHCP) or manually assigned.
IP ADDRESS xxx.xxx.xxx.xxx Current assigned IP address. To change,
press ENTER and use +/– keys to increment
1st octet, then press ENTER again to move
on to next octet. When 4th octet has been
set, press ENTER again to register new
address.
SUBNET MASK xxx.xxx.xxx.xxx Current assigned subnet mask. To change,
proceed as above.
GATEWAY ADDRESS xxx.xxx.xxx.xxx Current assigned gateway address. To
change, proceed as above.
INITIALIZE NIC? EXECUTE Initialises the network hardware.
WEB/IPP ENABLE / DISABLE Enables or disables Web config. facility and
Internet Printing Protocol.
TELNET ENABLE / DISABLE Enables or disables Telnet config. facility.
FTP ENABLE / DISABLE Enables or disables communication via FTP.
SNMP ENABLE / DISABLE Enables or disables SNMP protocol.
LAN NORMAL / SMALL Selects network size.
HUB LINK SETTING AUTO NEGOTIATE
100BASE-TX FULL
100BASE-TX HALF
10BASE-T FULL
10BASE-T HALF
Sets full or half duplex for communication
via a network hub.