Filter
Top Products
INSTALLING UPGRADES > 187
10.
Hold the new memory board by its short edges, so that the
edge connector faces in towards the RAM expansion slot, and
the small cutout is closer to the rear of the printer.
11.
Gently push the board into the RAM expansion slot until it
latches in and will not go any further.
12.
Locate the three retaining clips at the bottom of the side cover
into their rectangular holes near the bottom of the printer.
13.
Close the top of the side cover up to the printer and refit the
securing screw removed in step 4.
14.
Close the front cover and close the top cover, pressing down
firmly at each side to latch it closed.
15.
Reconnect the AC power cable and switch the printer on.
16.
When the printer is ready, print a menu map as follows:
(a)
Press the
+
button to access the Information Menu.
(b)
Press
ENTER
once for the menu map.
(c)
Press
ENTER
again to print the menu map.
(d)
When the menu map is printed, press
ON LINE
to exit the
menu system.
17.
Examine the first page of the menu map.
Near the top of the page, between the two horizontal lines, you
will see the current printer configuration. This list contains the
figure for total memory size.
This should indicate the total memory now installed, which
should be the size of memory board you have installed plus
64MB.
If you are using the Windows PostScript driver, follow the instructions
later in this section to adjust the driver.