Filter
Top Products
36
Error Message What to Do
OKI HSP CONNECT There is a problem with the OKI HSP connection. Check to be
sure that the print server is properly installed and that the
connection is secure. If message persists, contact your service
provider (see Section 4).
OPT CARD ROM There is a problem with the ROM on the optional interface card.
Try turning the printer off, then on again. If message persists,
contact your service provider (see Section 4).
OPT CARD CONNECT There is a problem with the connection to the optional interface
card. Check to make sure that the card is properly installed and
that the connection is firm, then try turning the printer off, then
on again. If message persists, contact your service provider (see
Section 4).
OPTICAL SENSOR Paper width sensor alarm. Try turning the printer off, then on
again. If message persists, contact your service provider (see
Section 4).
PAPER END Paper has run out. Load a new stack of continuous forms.
PAPER JAM Paper edge has ripped and caused a jam. Clear the paper jam
(see Section 2) and reload paper.
PAPER RELEASE The bail is partially open. Press SHIFT + PARK.
PARK JAM Paper jammed as it was being parked. Clear the paper jam (see
Section 2) and reload paper.
PATH CHANGE Path switching motor is not functioning properly. Contact your
service provider (see Section 4).
PATH CHANGE JAM Paper jam during change in paper path.
* 1. Check to be sure that paper is loaded in both paths.
* 2. Determine which path is jammed, then clear the jam and
reload paper.
POWER FAN Power supply fan malfunction. Contact your service provider
(see Section 4).
PROGRAM-ROM Try turning the printer off, then on again. If message persists,
contact your service provider (see Section 4).
RIBBON Ribbon motor not functioning properly . Try turning the printer
off, then on again. If message persists, contact your service
provider (see Section 4).