Filter
Top Products
Introduction and Installation
OMG-PCI-DIO48 Page 1
Introduction
Overview
The OMG-PCI-DIO48 provides two 8255 mode 0 compatible ports providing
four eight-bit ports and four four-bit ports. Each can be individually configured
as inputs or outputs. When configured as outputs each bit of the four bit ports
may be set or reset individually.
What’s Included
The OMG-PCI-DIO48 is shipped with the following items. If any of these items
is missing or damaged, contact the supplier.
• OMG-PCI-DIO48 Adapter
• Software
• Industry Standard Relay Rack Cables are Available:
Part number CA135 for Edge Connection
Part number CA167 for IDC Connection
Installation
Card Setup
The OMG-PCI-DIO48 is a fully compliant PCI ‘Plug and Play’ adapter. All card
resources (i.e. I/O address, IRQ selection) are auto-assigned by either your
system BIOS or your ‘Plug and Play’ operating system.
Software Installation
For proper operation install software first. To install the software place the CD in
your CD-ROM tray and the auto-run program will start. If auto-run is not
available browse the CD and choose “index.htm”. Choose Install Software at the
beginning of the CD. Select the Digital I/O software drivers and install SeaIO
prior to installing hardware.
Linux Users
Refer to the installation instructions at the beginning of the CD for details on
installing the digital I/O cards in Linux.