Filter
Top Products
4
in the shipment. Power on the AirEZY 2411 BT, the LEDs on the front panel
should exhibit the following patterns:
LED Color Light Blinking Pattern
ON RED Steady on
RX GREEN Steady on
TX RED on, when transmitting RF signal
LINK YELLOW Flickering when communicating over the Ethernet
port; steady-on when Ethernet connection is absent
If the yellow LED stays on continuously, then the Ethernet connection to the host
computer or device is not made. Check your UTP cable and make sure that a
straight-through cable is used for connecting directly to a host. A cross-over UTP
cable is needed if connecting to a hub. If the yellow LED is not lit, and power is
on to the device, then the Ethernet connection between the host computer and
the Wireless Ethernet Adapter is correct. If one cannot communicate, and the
yellow LED is off, you may want to re-position the AirEZY-2411-BT to a different
location for better RF reception. You may also want to check if the unit is
configured with the proper RF channel and security settings by using the Utility
software.
Once the hardware is checked out to work properly with the intended host device
or network equipment, the radio can be secured in the desire location by the pair
of Velcro tabs.
Velcro tab