Filter
Top Products
Advanced Tab
(.. /continued)
Note about the TRIMAR MAC address options:
The TRIMAR AP supports 2 MAC addresses, one used to address the
Ethernet port and the other the Wireless port. By default, these are set to
a particular unit’s hardware and are unique to the unit.
It is possible to manually enter and override the hardware MAC address by
entering the new MAC address information into the following areas:
WLAN MAC address field - Advanced Tab
Ethernet MAC address field - WDS Tab
(See on previous page Figure 20)
DTIM Interval: This value determines the frequency when the
radio will send broadcast/multicast packets to
stations in power save mode. This function is
associated with the Beacon Period.
Factory default: 1 (each beacon period or once every 100
milliseconds)
802.11d Global Harmonization control.
Factory default: Disabled.
Transmit Power: This controls the power output permitted to
the antenna. If the radio is causing
interference to another device, reducing the
antenna’s output may help alleviate the
problem. Do not reduce the power level for
any other reasons.
Factory default: High
WLAN MAC address: The MAC address of the wireless port. If left
blank, the factory preset MAC address will be
used. The factory default MAC address is
reported on the Information tab report screen.
Factory default: blank (hardware MAC address is used)
PEGASUS WIRELESS CORPORATION TRIMAR TECHNICAL MANUAL Version 1.0 Page 18 of 32