Filter
Top Products
59
[Preparation]
Preparation
Initial Status of the Front Panel Display (7 Segment LED)
Front panel display shows the following after turning on the power of the driver.
approx. 2 sec
approx. 0.6 sec
approx. 0.6 sec
...
Initial display of LED (Determined by the setup of
Parameter, Pr01 "Initial status of LED".)
•
Release of RS232 communication error
When RS232 communication error occurs
as the Fig, below shows, release it by
pressing and at the same time.
• Release of RS485 communication error
When RS485 communication error occurs as
the Fig, below shows, release it by pressing
and at the same time.
(Displays the version No. of this product.)
Press
(Displays the version No. of this product.)
(ID of the selected driver)
(ID of the selected driver)
Dot flashes when RS485 is connected.
Set up ID of the connecting Driver
with and .
(approx.0.6sec)
When ID No. of the driver is other than "0"
•
In case of communication with RS232 only
• In case of communication with other drivers
which are connected via RS485
When ID No. of the driver is "0"
1 sec
approx. 0.6 sec approx. 0.6 sec approx. 0.6 sec
[flashes for approx. 0.6 sec each for initialization of the console]
Displays version No.
of micro computer of
the console. (
Displayed
figures vary
depending on
the version)
Displays ID No. of the
Driver. (data of Para-
meter, Pr00)
Initial display of LED
(Determined by the
setup of Parameter
Pr01, "Initial Status of
LED".)
Initial Status of LED
Initial Status of the Console Display (7 Segment LED)
Turn on the power of the driver while inserting the console connector to the driver main body, or inserting the
console connector to CN X4 connector.