Filter
Top Products
9-12
9.2.3. Setting the Inverter PCB, TS PCB and LCD Unit
1. Set the LCD Unit to the LCD Front Cabinet in order.
2. Attach the 2 drop holders.
3. Connect the Cable to the Connector. (CN200,CN201)
4. Connect the 3 Cables to the 3 Connectors.
5. Fix the Inverter PCB using the 2 Screws <N6>
(No1 to No2).
Note:
Tighten the Screws in the numbered order (No1 to No2).
Screws <N6>: DRQT26+E4FKL
Preparation of Inverter
<N6>
<N6>
No.1
No.2
LCD Unit
LCD Front Cabinet
Inverter PCB
TS PCB
LCD Drop Holder
LCD Drop
Holder
A
B
A
B
C
C
to Connector
(CN200)
Connector
(CN200)
Connector
(CN201)
INV PCB
㪥㪇㪞㪝㪉㪡㪇㪇㪇㪇㪇㪊
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
1. Apply the load when attaching the attaching parts. 20 to 30N (2 to 3Kgf)/cm2
2. When handling INV PCB, do not bend or add an impact.
<Notes>
N0GF1J000009
(Non T/S model)
Check the
product number.
N0GF1J000009
Prepare INV Shield Case
and INV Shield Case
Outside for Assysite.
INV Shield Case Outside
INV Shield
Case
N0GF2J000003
Check the
product number.
Board attachment
Set and attach.
INV Case
INV Shield Case
Set
Match the board edge and the case edge.
Misalignment: 0.5mm or less
Attach it putting the protrusion mark next to the caution label.
Wrap 2 INV Shield Tapes around INV Shield
Case and attach.
Ensure that INV Shield Tape does not run over
the edge of INV Shield Case.
INV Shield Tape
Attach.
<INV Shield Tape's Attachment Guide>
Protrusion by wrinkles, etc. = 0.2 or less
Air Bubble = 1 cm2 or less / 1 bubble size
S4
S4