Filter
Top Products
9-29
䡾
䢁
FPC HDD BATT Set
㪘
㪙
㪚
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
BATT HDD CN
ANGLE Set
HDD GUIDE
Set
View from A
direction
Screw
Tighten
Screw-1
Tighten
Screw-2
Tighten
Do not fold.
This Connector does not need tetra coating.
Note for attaching the Flex to the metal.
Insert so that the
stiffening plate side
touches.
٤ Correct operation
Wrong operation
View from B
direction
Battery Connector
View from C
direction
HDD Connector
1. Set HDD GUIDE and fix with Screw.
2. Fix with Screw.
3. Apply tetra coating to each Connector pin.
(Refer to M14 in "Common Assembly Instruction Manual".)
HDD Connector : Set the nozzle tip apart from the Connector with 1
to 10 mm and spray from the Connector end to the
end one way for about 1 minute.
Battery Connector : Set the nozzle tip apart from the Connector with
1 to 10 mm and spray from the Connector end
to the end for about 1 minute. Do the same to
the opposite direction.
Torque of tightening screw :
0.19
± 0.02N·m(Ṑ
2.0
± 0.2kgf·cm)
䎃
䌎䌇
䌏䌋
The terminal of the antenna
cable must not come in
contact with this terminal.
(Put it on the metal fittings
side. )
FPC CUSHION
Cable
Relay circuit board Assy
FPC
FPC
Valley Fold (Dotted line)
Valley Fold (Dotted line)
Fold along the level of the outer shape.
Valley Fold (Dotted line)
Mountain Fold (Full line)
Mountain Fold (Full line)
After folding
(R0.5~1)
ޝFIG1ޞ
Lock after inserting FPC.
Lock FPC
Don't use a mistaken thing.
2. Don't mistake a bending direction.
1. The bending inside is R0. 5~1ޝFIG1ޞ
ޝThe attention of foldingޞ:Breakage countermeasure.
Figure seen from direction of arrow of A
FPC insertion guidline
Ensure the FPC edge is
at the steel plate edge.
(Misalignment: 0.5 or less)
Reference
1.5mm
Insert plug into socket
A
Match the hook of
Connector lock to the center.
Insert FPC into Relay
circuit board Assy's socket