Panasonic CF-W8 Personal Computer User Manual


 
126
Troubleshooting (Advanced)
The device will not operate properly if a different mouse driver is installed
z When you install a different mouse driver, such as IntelliPoint for Microsoft’s IntelliMouse, the mouse driver currently
installed in the computer may need to be uninstalled.
For information on how to uninstall the driver, refer to “When Using an External Mouse”. (Î page 76)
z If not using the Touch Pad, and using an external mouse only, set [Touch Pad] to [Disable] in the [Main] menu of the Setup
Utility. (Î page 99) And uninstall the mouse driver that is installed on this computer.
A PC Card does not work
z Confirm that the card conforms to the PC Card Standard.
z Make sure the card is properly inserted (Î page 65).
z Check that the proper port settings have been made.
A Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
B Double-click [PCMCIA adapters], and double-click the relevant device.
In [Resources], if [Conflicting device list] shows [No conflicts], there is no conflict.
z Read the instructions supplied with the PC Card, or consult the PC Card manufacturer.
z Check that you are using a driver supported by the operating system.
You do not know the available RAM module
z Refer to Operating Instructions “Expanding Memory” or “Specifications”.
To check if the additional RAM module has been installed successfully
z If the installation is successful, the main memory and total RAM module size appears in the [Information] menu of the
Setup Utility (Î page 98).
z If the RAM module is not confirmed:
Turn the computer off and reinsert the RAM module.
Confirm the recommended specifications.
Regarding the RAM module, refer to Operating Instructions “Expanding Memory” or “Specifications.”
The address map for IRQ, I/O port address, etc. is unclear
z You can check with the following procedure.
A Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager].
B In the [View] menu, click [Resources by type].