Filter
Top Products
9. Programmable Features
69
Code #41: Changing the fax activation code
FAX ACTIVATION
=ON [±]
If you wish to use the cordless handset (page 49)
or an extension telephone (page 49) to receive
faxes, activate this feature and program the
activation code.
1. Press {MENU}.
2. Press {#}, then {4}{1}.
3. Press {A} or {B} repeatedly to select “ON”.
4. Press {SET}.
5. Enter your code (2 to 4 digits) using the dial
keys {0}–{9}, {*} and {#}.
L The default code is “@#9”.
L Do not enter “0000”.
6. Press {SET}.
7. Press {MENU}.
Code #44: Setting the memory reception alert
RECEIVE ALERT
=ON [±]
To alert you with a beeping sound when a
received fax document is stored into memory
due to some existing problem.
The slow beeps will continue until you clear the
printing problem and make sure the unit is
supplied with enough paper to print the stored
document.
“ON” (default): You will be alerted to a reception
problem by a beeping sound.
“OFF”: Deactivates this feature.
Code #46: Setting friendly reception
FRIENDLY RCV
=ON [±]
To receive a fax automatically when you answer
a call and hear a fax calling tone (slow beep).
“ON” (default): You do not have to press
{FAX/START} for fax reception.
“OFF”: You have to press {FAX/START} for fax
reception.
Code #54: Changing the recording time for
your TAM/FAX greeting message
GREETING TIME
=16s [±]
“16s” (default): Maximum recording time is 16
seconds.
“60s”: Maximum recording time is 60 seconds.
See page 57 for details.
Code #58: Setting the scan contrast
SCAN CONTRAST
=NORMAL [±]
To send or copy a document with faint or dark
writing, set this feature before transmission or
copying.
“NORMAL” (default): Used for normal writing.
“LIGHT”: Used for faint writing.
“DARKER”: Used for dark writing.
Code #67: Setting the greeting message
monitor
GREET MONITOR
=ON [±]
To select whether the greeting message is heard
through the unit’s speaker when the unit answers
a call.
“ON” (default): You can monitor the greeting
message.
“OFF”: Only the caller message will be heard
through the speaker.
Note:
L You can also program this feature with the
cordless handset (page 61).
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON [±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
“ON” (default): To send a fax even if there is
static interference on the telephone line.
“OFF”: Deactivates this feature.
Note:
L You cannot change the setting when received
documents are in memory.
Code #74: Setting the location where you use
this unit
LOCATION
=AUSTRALIA [±]
This setting must match your location.
“AUSTRALIA” (default): To use in Australia.
“NEWZEALAND”: To use in New Zealand.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON [±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
FC243AL-PFQX2096ZA-en.book Page 69 Thursday, September 30, 2004 3:37 PM