Filter
Top Products
Setup (KX-FP155 only)
49
TAD/FAX mode!
(receiving phone calls and faxes automatically)
Setting up the voice and fax message reception
When TAD/FAX mode is set, the unit will work as a fax machine and/or answering device.
If a fax tone is detected, the unit will automatically receive the fax. If a phone call is detected, the
answering device will play a greeting message and the caller can leave a voice message.
Note:
●
The incoming message recording time can be
changed (feature #10 on page 63).
●
When the remaining time is low, erase unnecessary
messages (p. 52). For the voice memory capacity for
incoming messages, see page 83.
●
While an incoming call is being recorded, you can
monitor it through the speaker. If this feature is not
required, set feature #67 to off (p. 69).
AUTO ANSWER
1
Make sure that feature #77 is set to
“TAD/FAX” (p. 71).
2
If the arrow (
▼
) is not shown on the right of
the display, turn it on by pressing
PQ.
Display:
●
The unit will play the pre-recorded greeting
message.
●
The remaining time for recording incoming
messages will be displayed.
Example:
●
You can change the speaker volume.
Press + or - while listening to the
greeting message.
_TIME_=_10m13s
TAD/FAX MODE
Ring setting in TAD/FAX mode
You can choose from 2, 3, 4, 5, 6, 7, 8, 9,
TOLL SAVER and RINGER OFF.
This setting can be changed by feature #06 on
page 62.
TOLL SAVER: When you call the unit from a
remote location, the number of rings will tell
you if there are any new voice messages. If the
unit answers on the 2nd ring, there is at least
one new recorded message. If the unit
answers on the 4th ring, there are no new
recorded messages. To save the toll charges
for the call, hang up immediately when you
hear the 3rd ring. The 3rd ring indicates that
there are no new recorded messages.
RINGER OFF: The unit will answer without
ringing.