Filter
Top Products
Technical information
ENGLISH - 115
Appendix
Cable specication
z
When connected to a computer
Projector
(<SERIAL> terminal)
1 NC NC 1
Computer
(DTE specications)
2 2
3 3
4 NC NC 4
5 5
6 NC NC 6
7 7
8 8
9 NC NC 9
Control command
The following table lists the commands that can be used to control the projector using a computer.
z
Projector control command
Command
Details Notes (parameter)
PON Power on
In the standby mode, all commands other than “PON” are invalid.
During lamp On control operation, the “PON” command is not accepted.
POF Power off
If the “PON” command is sent while the cooling fan is operating after the lamp has turned
off, the lamp On control operation will start 85 seconds after the lamp has turned off, in
order to protect the lamp.
AVL Volume
(Parameter)
000 (adjustment value 0) to 063 (adjustment value 63)
IIS Switch input modes
(Parameter)
VID = VIDEO SVD = S-VIDEO RG1 = COMPUTER
HD1 = HDMI 1 HD2 = HDMI 2 YUV = COMPONENT
Q$S Lamp condition query
(Call back)
0 = Standby
1 = Lamp On control active
2 = Lamp On
3 = Lamp Off control active
OSH AV Mute function
The video and sound turn off temporarily.
Sending the command switches on/off. (
page 41)
Do not switch on/off in a short period of time.
Menu lock password
To initialize your password, consult your distributor.