Filter
Top Products
Switching on/off
38 - ENGLISH
Basic Operation
Switching off the projector
1) Press the power button.
z
The power off conrmation message is
displayed.
2) Press
to select [OK], and press
the <ENTER> button.
(Or press the power
button
again.)
z
Projection of the image will stop, and the power
indicator <ON (G)/STANDBY (R)> on the
projector illuminates orange.
(The fan continues to operate.)
3) Wait until the power indicator <ON (G)/
STANDBY (R)> of the projector turns
red (until the fan stops).
4) Press the <OFF> side of the <MAIN
POWER> switch to turn off the power.
Note
z
Select [CANCEL] or press the <MENU> or
<RETURN> button to close the power off
conrmation message.
z
The power can also be switched off when the power
button is pressed for at least 0.5 seconds.
z
Do not turn on the power immediately after
turning it off.
In the cooling state of the luminous lamp after the
power is turned off, the lamp may not illuminate
even if the power is turned on. After the power
indicator illuminates or ashes red, turn off the
main power and then back on again. Turning on the
power while the lamp is still hot may shorten the
lamp life.
z
Even when the power
button is pressed
and the power is turned off, the projector
consumes power if the main power is on.
Refer to “Power consumption” (
page 118) for the
power consumption.
Direct power off function
Even if you turn the <MAIN POWER> switch <OFF>
during projection or just after the luminous lamp turns
off, the fan will rotate using internally stored power to
cool the luminous lamp. In cases where the <MAIN
POWER> switch is not easily turned <OFF>, such as
during ceiling mount, you can safely turn off the power
by using the power breaker switch. This function also
works if a power outage occurs or if the power cable
is accidentally disconnected from the outlet right after
turning off the power.
Note
z
If projection was stopped by turning off the power
breaker switch and you turn on the power breaker
again, the power indicator <ON (G)/STANDBY (R)>
illuminates green and projection starts again.
(When the [PROJECTOR SETUP] menu
→
[INITIAL
START UP] (
page 67) is set to [LAST MEMORY]
or [ON].)
z
When the lamp has been cooled by the direct
power off function, it may take longer than usual for
the projector to start projection again.
z
Conrm that the fan has stopped before packing
the projector to transport or store.
3RZHULQGLFDWRU21*67$1'%<5!