Filter
Top Products
[PROJECTOR SETUP] menu
ENGLISH - 69
Settings
7) Press
to select [TIME] or
[COMMAND], and change the settings
according to the operation instructions
of the menu.
[TIME]
Sets the time at which the command
will be executed using
.
[COMMAND]
Selects a command to execute at the
set time from the following.
[POWER ON]
[STANDBY]
[AV MUTE] [ON]
[OFF]
[INPUT] [COMPUTER]
[VIDEO]
[S-VIDEO]
[COMPONENT]
[HDMI 1]
[HDMI 2]
[LAMP POWER] [NORMAL]
[ECO]
[IN STANDBY MODE] [ON]
[OFF]
[VOLUME]
8) Press
to select [STORE], and
press the <ENTER> button.
Note
z
If you try to register a setting that would cause the
lamp to ash for a short time, an error message will
be displayed on the screen and the setting will not
be registered. Set the time and command again.
z
If multiple commands have been set for the same
time, they are executed in chronological order
starting from the smallest command number.
z
The operating time will be the local time. (
page 73)
z
If an operation is executed with the remote control
or control panel of the projector or with a control
command before the command set in [SCHEDULE]
is executed, the command set with this function
may not be executed.
[ECO MANAGEMENT]
You can optimize lamp power and reduce the power
consumption according to the application.
1) Press
to select [ECO
MANAGEMENT].
2) Press the <ENTER> button.
z
The [ECO MANAGEMENT] screen is
displayed.
3) Press
to select an item.
When [AUTO POWER SAVE] was
set in Step 3)
You can enable [AMBIENT LIGHT DETECTION],
[SIGNAL DETECTION], and [AV MUTE DETECTION]
functions.
Note
z
This setting is not available if [LAMP POWER]
(
page 68) is set to [ECO].
4) Press
to switch [AUTO POWER
SAVE].
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON]
Enables the auto power save
function.
[OFF]
Disables the auto power save
function.
5) Press
to select [AMBIENT LIGHT
DETECTION], [SIGNAL DETECTION],
or [AV MUTE DETECTION].
[AMBIENT
LIGHT
DETECTION]
Adjusts the lamp power according
to the ambient brightness.
[SIGNAL
DETECTION]
Drops the lamp power when no
signal is input.
[AV MUTE
DETECTION]
Drops the lamp power in the AV
Mute mode.
6) Press
to switch the setting.
z
The setting will change as follows each time
you press the button.
[ON] [OFF]
[ON] Enables the setting.
[OFF] Disables the setting.