Filter
Top Products
TC9800UWSG Rev. AB 12/07 ©2005 Paxar Americas, Inc. a subsidiary of Avery Dennison Corp.
All rights reserved.
USING THE EXTERNAL UNWINDER
The Monarch® 945™ External Unwinder is an optional device used with
the Monarch® 9855® and 9860® Printers. The unwinder is capable of
holding a 12 inch roll of supply. It unrolls inside or outside wound
supplies. The unwinder comes assembled. These instructions help
explain how to set up and use the unwinder.
Assembling the Winding Axle Flanges
1. Slide the flange with the small setscrew on the axle end that has a
setscrew groove. Make sure the setscrew seats in the groove and
tighten it.
2. Slide the roll of supply onto the axle then the flange with the large
thumbscrew and tighten it.
3. Place the axle assembly into the notches of the unwinder frame.
Setscrew Groove
Small Setscrew
Large Thumbscrew